I make a few novelty products, at www.awkwardengineer.com. Sourcing an injection molder was a true challenge. I attended a tradeshow, www.d2p.com, and found that there were dozens of injection molders in the area, small businesses, that had absolutel

Sam , 29.11.2012, 11:18

Response from the site administrator

makersrow, 04.12.2012

Hello! We just launched on October 24 and will be expanding into new categories and industries soon! Thanks for your feedback! We are very excited to expand into new industries too :)

Idea status: under consideration

Comments

Without registration

Name		Required
e-mail		Required

Login		Use 3 to 18 characters, Latin characters or numbers	This login is not availableThis login is available
e-mail
Password		Use 3 to 18 characters, Latin characters or numbers
Re-type password
	Remember me

	Sign up

What is Idea Informer?
RSS feed


E-mail

I make a few novelty products, at www.awkwardengineer.com. Sourcing an injection molder was a true challenge. I attended a tradeshow, www.d2p.com, and found that there were dozens of injection molders in the area, small businesses, that had absolutel

Comments

Leave a comment